Archer c80 - after a few hours setting will be set to the original values

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer c80 - after a few hours setting will be set to the original values

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Alexandr87

2021-12-20 08:00:31

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-12-20

Archer c80 - after a few hours setting will be set to the original values

2021-12-20 08:00:31

Model: Archer C80

Hardware Version: V1

Firmware Version: 1.10.0 Build 210716 Rel.51301n(4555)

Good day,
please advise about the Archer C80.
I perform the settings of the wifi router (web interface), I save the changes, everything is set as it should. But after a few hours it will be set to the original values (the 5G network I have deactivated will be switched on again; the setting of the 2.4G network switching-off time will be deactivated; the TPlink account will be logged out)

1 Reply

Kevin_Z

2021-12-22 02:48:11

Posts: 21607

Helpful: 5054

Solutions: 2546

Stories: 21

Registered: 2018-12-24

Re:Archer c80 - after a few hours setting will be set to the original values

2021-12-22 02:48:11

@Alexandr87

Hello, have you enabled the Wi-Fi Schedule on the C80? If yes, that would be the case that the Wi-Fi Schedule will enable both 2.4GHz and 5GHz at the same time. This has been reported to the developers and it would be optimized in the future firmware update, you may keep an eye on the official website for new firmware updates in the future.

Regarding the TP-Link account concern, when you login to the router web GUI by entering the device username and password, it will login locally by default. It looks like you are unlinked from the TP-Link Cloud when you go to the TP-Link ID page, but that is not true, you just reenter your TP-Link ID credentials, you can still login and link to the cloud account fine. This may be misleading, we will see how to improve this in the foreseeable future.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Archer c80 - after a few hours setting will be set to the original values

Archer c80 - after a few hours setting will be set to the original values

Information

Voters 0

Tags