Hello.

I cant get a PC application to access the ports it needs to operate.

I need to open the following UDP Ports: 46100, 46110, 46112, 46114, 46120 and 46122.

Previously, I used a BT Whole Home wifi mesh network, and opened the necessary ports in the Plusnet Broadband Router. All was working OK.

Now having installed the Deco x20, I cant seem to get the ports open and mt application that needs them open, says they are not open.

I belive I have opened the ports in the iPhone Deco App and applied the port mapping to the IP address of the PC needing them open, and fixed the IP to that PC.

I have enclosed screenshots below, to show settings applied.

Not sure now If I stll need to make any other changes to make this work. 

Hope someone can assist.

Thanks.