Red light for m4
Hi,
We recently had our internet repaired after that i noticed that the deco light went to solid red. I have tried to download the upgrade firmware but i cannot open the management website to upgrade my deco
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, When M4 turned red, if you go to Deco APP>More>Advanced>ipv4. any IPV4 address here?
What is your current firmware version by the way?
And have you tried to connect a computer to the internet service provider to confirm your internet service has been repaired?
- Copy Link
- Report Inappropriate Content
@David-TP hello
IPV4 address : 192.168.1.12
Firmware version : 1.5.1 build 20210609 rel 69473
Yes internet is already working and repaired
- Copy Link
- Report Inappropriate Content
Hi, I see the firmware-1.5.1 Build 20210609 Rel. 69473 is a customized firmware for PLDT and is your service provider also PLDT?
So far, I did not see any newer firmware than this.
And the IPV4 address here is a private address, is your internet connection type Dynamic IP?
Would restarting the main Deco and the ISP modem make any difference?
By the way, Have you ever tried to unplug the main Deco M4 and plug the computer into PLDT modem and check what the IP address on the laptop is?
How to find IP address on your devices?
- Copy Link
- Report Inappropriate Content
dynamic ip for both deco and pldt
No difference when restarting deco and modem
Laptop ipv4 ip 192.168.1.10
- Copy Link
- Report Inappropriate Content
Hi, have you seen the private message, and could you please leave me a message about your TP-Link email ID for the Deco APP?
May I know the model number of your PLDT ONT/ONR
Could you please refer to this link to clone the MAC address of laptop to Deco in case PLDT required MAC authentication?
How to Configure MAC Clone on Deco if Deco fails to connect to the internet?
By the way, did you test the laptop connected to the same port(that used to connect Deco) on PLDT ONT/ONR?
I used to get the feedback that on some ONT/ONR, like, there are 4 ports on it but only one port is ready for use and if you wanted more, you might need to contact PLDT to re-activate more ports.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 718
Replies: 5
Voters 0
No one has voted for it yet.