Home Network Community > Deco > Deco M5 Jittering
< Deco

Deco M5 Jittering

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M5 Jittering

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M5 Jittering
Deco M5 Jittering
2022-04-27 16:39:05
Model: Deco M5  
Hardware Version:
Firmware Version: 1.57

Hi, just got my 3 nodes Deco m5v3 and experiencing lagging probably because of my config. 

My ISP modem IP is 192.168.55.1 and give assign DHCP for my main Deco as 192.168.55.101

However in my phone app, the Lan IPv4 address is 192.168.55.101

What should I do to fix the jitter ? Is there any conflict in the ip address or should I set Deco as access points and let the ISP modem assign DHCP ?

  0      
 
  0      
 
#1
Options
4 Reply
Re:Deco M5 Jittering
2022-04-27 20:21:59

  @Louis13 

 

It makes sense to switch Deco mesh to Access Point mode, if you don't need Router mode features. That could improve Deco mesh performance. It also might reduce jitter, but no guarantee. In any case, it'll simplify your network setup, and that is always good.

  0  
  0  
#2
Options
Re:Deco M5 Jittering
2022-04-28 03:52:14

  @Alexandre. Some said AP mode will reduce the speed or is it just a myth ? And also which way is better:

- Isp modem router -> 3 node

- modem -> main node -> switch -> nodes

  0  
  0  
#3
Options
Re:Deco M5 Jittering
2022-04-28 05:41:15

  @Alexandre. I alr changed to AP mode, however in the deco app it still show 1 node as the main node. Is it normal ?

  0  
  0  
#4
Options
Re:Deco M5 Jittering
2022-04-28 06:03:35

  @Louis13 

Hi, AP mode would not cap the speed and the best connection would be:

                                          /---AP2

ISP modem router---switch---AP1

                                          \---AP3

General questions about Ethernet Backhaul feature on your Deco

And as long as all three M5s are under the same Mesh, there will be only one "main" Deco.

Thank you very much.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Wi-Fi Heatmap ready for Test! ▶Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN ▶Deco BE65_V2_1.2.10 New Firmware with Enhanced Stability & Interference Resistance ▶Deco BE75 1.1.0 Added WireGuard VPN, Manual Channel Selection and More Try to leave a Message if urgent help is required.
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 426

Replies: 4

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.