AC1200 wired connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AC1200 wired connection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

arphillips

2022-06-03 22:05:16

Posts: 5

Helpful: 4

Solutions: 0

Stories: 0

Registered: 2022-06-03

AC1200 wired connection

2022-06-03 22:05:16

Model: Deco M4

Hardware Version:

Firmware Version: 1.6.0

I have 3 Deco's setup in a mesh. One if wired into my router. Everything on Wifi works fine.

Each time my wired Windows PC boots it shows that the network port us unplugged, disabling it and enabling it fixes the issue. However I don't want to do this for the rest of the PC's life.

I know that this isn't an issue with the PC, it has been tested on other networking equipement and comes up first time each boot. Other machines (pi's and laptops) also have the same issue.

I have tried setting a static IP and using dynamic. I have also tried both ethernet ports on the Deco unit.

Any suggestions would be appreciated.

5 Reply

terziyski

LV7

2022-06-04 13:17:42 - last edited 2022-06-05 14:00:26

Posts: 7133

Helpful: 5344

Solutions: 1210

Stories: 7

Registered: 2013-10-12

Re:AC1200 wired connection

2022-06-04 13:17:42 - last edited 2022-06-05 14:00:26

@arphillips

Have you tried with a different ethernet cable or plug the PC to the other M4 unit ?

Sometimes bad cabling can cause such an issue - use a factory made CAT 5e/6 cables to be sure that you can achieve 1 gbps connection to the M4.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".