Archer VR2800 & Virgin Hub3
I have managed to set my virgin hub to modem. after many searches and videos watched, i know to remove all the ethernet cables & only use port 1 & to use the wan port on the Archer but after that i seem to be stuck. All the other comments i have found on this refer to different models and says to change the archer to wifi mode but this doesnt appear in the menu (as far as i can tell)
do i need the username and password details from virgin to be able to do this or am i just getting the sequence of plugging and unplugging wrong?
could someone please give me a list of simple steps to take after turning the virgin hub into modem only
thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
thank you
after a couple of error messages saying a vlan already existed i have now got it to work
thanks for your help
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@terziyski thanks i had seen that.
I have not had a problem switching the hub to modem only, i have removed all wires
i do not have a problem setting the VR2800 to wireless router mode, i have connected the cable to the wan port on VR2800 & port 1 (top one) on Hub3, dhcp is set to enabled
it all seems to go fine but there is no wifi available
tried it in different order, rebooting, still nothing
so i must be missing a step
- Copy Link
- Report Inappropriate Content
@terziyski the lights on the VR2800 are all green except the internet light is orange/red showing there is no connection, when i test the connection it is saying there is no internet ie the diagram showing each step is showing as not connected at step 1
- Copy Link
- Report Inappropriate Content
Upon successful configuration you should have the following screen: Internet icon with yellow checkmark (not a red cross):
Internet Status: Connected
Connection Type: Dynamic IP
IP address: <your public IP address>
If you have followed the instructions in the threads I posted you should be fine.
There's also a plenty of posts in the VirginMedia community about this type of configuration.
Let us know the outcome.
- Copy Link
- Report Inappropriate Content
so i am supposed to go to this page and amend it to dynamic ip address?
thanks
and then use the IP from here and the gateway etc?
- Copy Link
- Report Inappropriate Content
1. Change the VR2800 operation mode to wireless router:
2. Delete existing internet connections if any and Add new one of type Dynamic IP:
3. Click Save button when done configuring.
4. Connect ethernet cable between port 1 of the VM Hub3 to VR2800's LAN4/WAN port.
5. Restart VM Hub3 and then restart VR2800.
- Copy Link
- Report Inappropriate Content
thank you
after a couple of error messages saying a vlan already existed i have now got it to work
thanks for your help
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1184
Replies: 8
Voters 0
No one has voted for it yet.