Archer GX90 stuck in boot loop / bricked

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer GX90 stuck in boot loop / bricked

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer GX90 stuck in boot loop / bricked
Archer GX90 stuck in boot loop / bricked
2022-10-17 14:47:28 - last edited 2022-10-17 14:49:07
Tags: #bricked
Model: Archer GX90  
Hardware Version: V1
Firmware Version: unknown

My gx 90 appears to be stuck in a boot loop or it has somehow bricked its self.

 

I speant an hour in the chat with support but we just went round in circles does anyone have a fix for this or any suggestions on how to fix.

 

from power on the LED does this:-

 

flashes orange then turns solid blue for a few seconds than flashes orange again

 

Thanks

Si

 

  0      
  0      
#1
Options
1 Reply
Re:Archer GX90 stuck in boot loop / bricked
2022-10-18 01:29:00

Hello @Simoncmo 

 

Thank you for reaching out to us and welcome to the TP-Link community.

 

If the router behaves like that, please check the below suggestions and proceed: 
1. Please be sure you are using the original power adapter, which should be 12 V ⎓ 5 A.
2. If possible and to make sure this is not an adapter issue, you may try another power adapter with the same power specification.
3. Try to reset it by holding the reset button for 10s or longer to see if it will change anything.
4. Is there any power outage/bad weather before it behaves like this?

 

If nothing helps, it's suggested to contact the local tech support, so they can work with you in looking into the issue further or help with the replacement:
https://www.tp-link.com/support/contact-technical-support/#Hotline-Support

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options