@David-TP 

 

Hi, Thank you 

 

I am indeed connected to DSL, the old router is back in play and is syncing at:

 

Downstream sync speed: 65.209 Mbps

Upstream sync speed: 16.986 Mbps

 

I've presently returned to the supplied hub and am using my Deco's as an access point. I haven't (yet) tried the other settings you suggested but I will and report back. I may wait for a new firmware version to see if it makes any difference. 

 

Info from DSL-X73 

 

 

DSL

 

Line Status:

Connected

DSL Up Time:

0 days 0 hours 31 minutes

DSL Modulation Type:

VDSL2

Annex Type:

Annex auto

Current Rate (up/down):

11190/67620kbps

Max Rate (up/down):

11219/81347kbps

SNR Margin (up/down):

6/6dB

Line Attenuation (up/down):

15/9dB

Errors (up/down):

0/8pkts

 

 

I can change DSL modulation type:

 

bold is selected

autosync-up

T1.423

VDSL2

(Ive ignored the ADSL listed as this is FTTC)

Annex type:

auto* 

Annex A/L

Annex B/L

Annex A/I/J/L/M

 

Bit swap (is on)

SRA is off

 

I promise to report back on this thread in the near future as I will want to use the DSL-X73 as it was expensive. I can also set it up independently/alone and check settings there without wrecking my existing setup.  I'll be back as soon as, and thank you for the reply, I'll aslo include some cabinet info 

 @David-TP

 

Thanks but your suggestions made no difference to upload sync. My BT router firmware now has a lot of extras like IPv6 info and Pinhole additions. I have added it as a simple extra mesh deco until a new firmware is released which may help with the autosetup. 

 

Cheers

 

John

HI

 

I did some reading for a week (always good) and note that the X20-DSL had been pushed a (beta) firmware update which fixed a problem with connecting via BT VDSL. I'd like someone from tp-link to reply to this thread when a new firmware is pushed to the X73-DSL so I can try that for this upload problem please. I'll check back periodically as well, otherwise I've dumped £179 down the drain :(

 

I've added the X73-DSL as an access point mesh device so hopefully I'll see a upgrade when it's released, unless you would like me to try beta, which I'm happy to do.

 

Cheers for the help so far all, I'm very gratefull. 

 

John