Deco X95 - Not working with TP Link Switch

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X95 - Not working with TP Link Switch

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco X95 - Not working with TP Link Switch
Deco X95 - Not working with TP Link Switch
2023-01-22 05:35:25
Tags: #ethernet
Model: Deco X95   TL-SG1024D  
Hardware Version: V1
Firmware Version: 1.0.2

Have installed the Deco X95 to replace a damaged Archer AX90. The wired devices were working fine with the AX90 through the switch, however through the Deco X95, whilst they show as connected and obtain an IP, they fail to have any internet connectivity..

 

I swapped out the switch with a spare consumer grade 8 port DLink device and the 7 connected devices all connect, get IP's and have perfect internet connectivity, so it isnt the device or the cabling, it has to be an issue between the Switch and the Deco router.

 

What is puzzling is the same switch was working fine with the Archer AX90...

 

(Side note, i have an open case with TP Link, but the business support is only M-F for the switch)

 

Any ideas on what might be causing this issue???

  0      
  0      
#1
Options
1 Reply
Re:Deco X95 - Not working with TP Link Switch
2023-01-30 06:41:59

  @DoinitSideways 

Hi, Have you tried to connect the switch to a different port on Deco X95, or connect to satellite X95?

Would it be caused by static IP on the wired clients?

Best regards.

  0  
  0  
#2
Options