RE305 v4 hang after firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE305 v4 hang after firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RE305 v4 hang after firmware update
RE305 v4 hang after firmware update
2023-01-23 19:46:42
Model: RE305  
Hardware Version: V4
Firmware Version: RE305(EU)_V4_1.0.11 Build 220805

Hello, after firmware update my RE305 hangs after few seconds. 
Doing a hard reset doesn't help......
- How can I back to stock firmware ?  
- Maybe beta firmware is available ?

  0      
  0      
#1
Options
4 Reply
Re:RE305 v4 hang after firmware update
2023-01-30 01:47:34

  @big23 welcome to the community.

Do you use Tether APP to update the firmware of RE305?

May I know how long have you had the RE305?

Since RE305 does not support firmware recovery, if the extender is still under warranty, it is suggested to contact the shop retailer to get it replaced first.

Best regards.

 

  0  
  0  
#2
Options
Re:RE305 v4 hang after firmware update
2023-01-30 16:15:31

  @David-TP 

Hello, warranty was end last november. Tether app was used to install newest firmware. What can I do? It is strange, that I cannot revert firmware or back to stock via TFTP.. 

  0  
  0  
#3
Options
Re:RE305 v4 hang after firmware update
2023-02-18 14:26:21

  @big23 
Another repeater, another crash........
Sorry, I will never buy tp link again.All good until the warranty runs out... 6 repeaters updated, 2 into the trash can...

  1  
  1  
#4
Options
Re:RE305 v4 hang after firmware update
2023-04-24 18:53:04

  @big23 
Me too , 5 repeaters , 2 of them going to trash.....
For me, best way is to switch to another vendor ( Asus or DLink... )

  1  
  1  
#5
Options