Deco p9 igmp not available
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I think IGMP is required for my TV-provider, but I have no "system parameters" available in my web config. Seems to have read only access only.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
Update:
IGMP Proxy & Snooping is enabled by default and supports IGMP v1/V2/v3 and the IGMP Feature on/off button on the web UI is to decide whether IGMP v3 only is required.
If you have subscribed to an IPTV service, you could have a look at this link:
How to Configure IPTV function on Deco
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi, vendor states that IPTV is not in use, but IGMP v3 is required.
But I do not have a way of turning on IGMP v3 in the web config.
The System Properties is not available.
- Copy Link
- Report Inappropriate Content
Thanks for the update.
Could you please share some details or a configuration guide from the TV vendor?
By the way, Could you please also provide more details about what issue you have experienced on the TV? Maybe it is not related to IGMP settings.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi
I did some digging and found the vendor Telenor t-we (Norway) is spesifcally stating that IGMP V3 is required.
(All in Norwegian) https://www.telenor.no/binaries/privat/kundeservice/tvhjelp/utstyr/tredjeparts-utstyr/IPTV%20tredjepart%20veiledning%20juni%202020.pdf
Initial setup of the decoder box are not able to find any of the channels available. Network connectivty is OK, as software updates etc. are working fine.
Since the IGMP button in web-config is not available does that mean that my hardware does not support the feature?
- Copy Link
- Report Inappropriate Content
Thanks for the update.
I checked with the engineer and Deco P9 does support IGMP V1/V2/V3. The IGMP on/off button on the web UI is to decide whether IGMP V3 only is required.
In other words, The IGMP on Deco P9 works in a mixed mode compatible with V1/V2/V3.
So if Telenor IPTV solution required IGMP V3, Deco P9 should still work well.
I googled a similar issue on the UDM router but the suggestions here seemed not applicable to Deco. And I might need to follow up on your case and consult the senior engineers for further assistance.
How to get Telenor T-We (IPTV) working on UDM(P) without Telenor router
Please check whether you could receive an email from me later.
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 608
Replies: 5
Voters 0
No one has voted for it yet.