Home Network Community > Wi-Fi Routers > Delete ip binding on Archer C80
< Wi-Fi Routers

Delete ip binding on Archer C80

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Delete ip binding on Archer C80

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Delete ip binding on Archer C80
Delete ip binding on Archer C80
2023-05-11 17:22:22
Model: Archer C80  
Hardware Version: V1
Firmware Version: 1.12.10 Build 230208 Rel.38878n(5553)

Hello

 

I'm trying to delete an old host from ip & mac binding, binding list. When I click the thrash icon, 'Operation Succeeded' message confirms it and the item dissapears.

 

But a second later, the same line reappears. I reboot and the hosts is still there.

 

It could be a bug or there is some related value not allowing that option?

 

Thanks

  1      
 
  1      
 
#1
Options
7 Reply
Re:Delete ip binding on Archer C80
2023-05-11 20:10:00

  @Fernando2112 

 

Check if you have this IP & MAC address set in Address Reservation table and delete it from there, then try again deleting it from the Binding List table:

 

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  1  
  1  
#2
Options
Re:Delete ip binding on Archer C80
2023-05-12 13:05:08

  @terziyski Hello

 

Yes, that's when I realized that something didn't work.

 

If a try to disable de ip reservations, the correct message 'This entry conflicts with an existing entry in IP & MAC Binding.' is shown.

But when click the thrash can to delete it, 'operation succeeded' and the row deleted 'fer-Latitude...'  re appears.

 

The same problem as in the Binding List..

 

  0  
  0  
#3
Options
Re:Delete ip binding on Archer C80
2023-05-12 15:20:29

  @Fernando2112 

 

Try the following - disable ARP Binding:

 

 

Delete the problematic record from the Address Reservation table:

 

Reboot the router, re-enable ARP Binding again and then delete the problematic record from the Binding list table.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#4
Options
Re:Delete ip binding on Archer C80
2023-05-12 15:53:02

  @terziyski 

 

It's not working... Even with Binding switched off (and restart),  when I try to remove the host from Address Reservation, 'Operation succeeded' and a second later the host re appears..

Anyway, after new restart, the host is still there.

 

  0  
  0  
#5
Options
Re:Delete ip binding on Archer C80
2023-05-13 13:32:45 - last edited 2023-05-13 13:42:40

  @Fernando2112 

 

While ARP Binding is turned off, have you tried to disable Address Reservation before deleting it :

 

If that doesn't work either probably this issue should be addressed by @Kevin_Z.

I'm sure that if you reset the C80 to factory defaults it will resolve this, but that doesn't seem to be reasonable.

It's also interesting to know if you have that issue with this particular device only or any listed in the Address Reservation table.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  4  
  4  
#6
Options
Re:Delete ip binding on Archer C80
2023-05-13 17:48:49

  @terziyski Hi

I tried all, I think. In the dhcp page, If I try disable that host, 'This entry conflicts with an existing entry in IP & MAC Binding.', shows. No matter if IP & Mac binding is enable or not.

I confirm that happens in both old hosts once configured on IP Binding and DHCP IP reservation.

 

Of course, is not a critical or important issue. There are a lot of local ip addresses to choose from... It's just weird.

 

Thanks

  0  
  0  
#7
Options
Re:Delete ip binding on Archer C80
2023-05-16 07:17:23

@Fernando2112 

 

I believe @terziyski has suggested all that I can suggest.

 

It's weird that those items cannot be deleted from the binding table. I remember some community users reported that they're unable to remove the offline devices from the Parental Control list, that's because those settings are saved in the router memory once configured. But I haven't heard about similar feedback that the IP & MAC Binding devices cannot be removed, I would like to have a specialist to help confirm.

 

They will contact you with your registered email address later. Please pay attention to your email box for follow-up. Thank you.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#8
Options

Information

Helpful: 1

Views: 984

Replies: 7

Related Articles
Archer C80 in Access Mode with static IP
356 0
Archer C80 - IP Addresses not being assigned for some devices, some of the time.
3576 0
Archer A8 MAC - IP binding
460 0
Archer C80 Unable to connect to the internet using Dynamic IP
763 0
Archer c80 firmware upgrade changed internal ip address
1383 3
Archer C80 V3?
545 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.