Archer A6 not working as wifi extender after power failure
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Archer A6 not working as wifi extender after power failure
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Since I've bought this model i have to reset this router after power failure as it refuses to connect to parent modem. It doesn't connect and even i cannot login and change settings. I've been through forums and did everything mentioned but it still didn't connect. Requesting TP-link to update the firmware or replace the device please.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Sunshine So far manually restarting 3 times, didn't reproduced the problem. Will Update again in a day or 2.
- Copy Link
- Report Inappropriate Content
@Sunshine Thanks a lot, this solution worked out, connection is stable and working well for over 24 hours now. Thanks a ton for the resolution.
Sunshine wrote
Hello, may I know the model number of your main router? And is the main router using fixed channel on both 2.4GHz band and 5GHz band?
One possible reason is that the main router is using automatic channel, thus it might change its Wi-Fi channel after a power failure or reboot, but the Archer A6 still uses the previous channel, which results in the failure of wireless connection between them.
Therefore, please try to change the Wi-Fi channel of your main router to be fixed one for both 2.4GHz and 5GHz Wi-Fi, for example, set channel 1, 6 or 11 for 2.4GHz Wi-Fi.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1505
Replies: 12
Voters 0
No one has voted for it yet.