Home Network Community > Deco > Connection bridge mode or PPPoE for Decos/TP link Archer2100
< Deco

Connection bridge mode or PPPoE for Decos/TP link Archer2100

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connection bridge mode or PPPoE for Decos/TP link Archer2100

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connection bridge mode or PPPoE for Decos/TP link Archer2100
Connection bridge mode or PPPoE for Decos/TP link Archer2100
2023-06-04 02:09:13
Model: Deco X20  
Hardware Version: V3
Firmware Version: not sure

Hi guys, I need help. Yesterday I went and purchased a Deco 2 pack x20 (ax1800) and placed one at back of house (where living room is) and one at front of house. The house is 30m long hence why I needed to get the Decos. Prior to getting these, I have had a TP link Archer 2100 modem router. If I want to make the Decos as the actual router, do I need to make the connection type Bridge or keep in PPPoE mode? 

I am having an issue with my eufy cameras as one is outside garage at front of house and one is up back of the house and are both getting weak signals (homebase is half way up hallway). I should be getting full signal from both cameras as they are BOTH metres away from the two decos at either end of the house.

Very new to this mesh stuff so any help would be amazing thanks guys!

  0      
 
  0      
 
#1
Options
2 Reply
Re:Connection bridge mode or PPPoE for Decos/TP link Archer2100
2023-06-06 11:44:38

  @Braddos 

Hi, Welcome to the community.

Archer 2100, do you mean Archer VR2100, the DSL modem router?

Back to the question, yes, it would be better to put Archer VR2100 to bridge mode and set Deco X20 into wireless router mode.

Thank you very much.

Best regards.

 

▶Check What's Currently Going on With Deco ▶Deco X50_V1_1.8.0 Significantly Expanded the Client Connection Details and Added Channel Selection ▶Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN ▶Deco BE65/BE65 Pro 1.2.0 Enhanced Mesh Network Stability and System Security ▶Deco BE75 1.1.0 Added WireGuard VPN, Manual Channel Selection and More Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options
Re:Connection bridge mode or PPPoE for Decos/TP link Archer2100
2023-06-20 11:09:16

  @David-TP Hi that i the correct model yes. I am not sure how to change these settings in my modem router but would that help give me a more solid connection also?

Cheers

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1426

Replies: 2

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.