Power loss during firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Power loss during firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Power loss during firmware update
Power loss during firmware update
2023-06-18 19:45:54

While updating firmware my phone "died" and the firmware wasn't completely downloaded. Now only the power lamp on the router is flashing, and there no connection from tether app to the router. What do I do to install the new firmware?

  0      
  0      
#1
Options
1 Reply
Re:Power loss during firmware update
2023-06-20 05:54:15

  @BXB 

 

If you try factory resetting the device by holding the reset button for about 10s, is there any response?

 

If the power LED is always flashing even after factory reset, I am afraid the device has been defective.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options