MR600 V3(EU) is not working with WIFI and partially with LAN connection after firmware upgrade
MR600 V3(EU) is not working with WIFI and partially with LAN connection after firmware upgrade
Hi,
I was upgraded the firmware version of mr600 V3 (EU) from version 220727 to 230506 (Archer_MR600v3_1.1.0_0.9.1_[230506-rel77096]_up_boot_Release_Beta_2023-05-06_21.34.31.bin).
Since then internet connection is not working with wifi, few links are opening few or not, very slow net speed, connects for some devices not to some.
Getting "connected without internet" in my mobile (I am using AIRTEL sim for router).
When I tried to downgrade the firmware version from 230506 to Archer_MR600(EU)_V3_220307 I am getting error code 71211. I have added both the screenshot for this error.
I request you to please send me the link to download the firmware version Archer_MR600(EU)_V3_220727 and downgrade the firmware.
suggest me if any other solution for this issue.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Sunshine
Hello,
I was using Jio sim previously so had to install the beta firmware, now i got relocated to a area where Airtel seems to have good strength.
Post firmware updated to Beta i am unable to use mr600 V3 with Airtel sim. could you suggest me a way forward please.
So far i have tried:
Flashing with Archer MR600(EU)_V3_220727, now mr600 does seem to pick up airtel signal (i just see 1 bar with no internet)
- Copy Link
- Report Inappropriate Content
hello,
you are right Iam not able to use airtel sim (india) after beta installation and now I don't have jio sim anymore. Can you suggest a way forward please.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, is your current firmware Build 230811? If so, when using non-jio SIM card, please make sure the PDP Type is not XLAT any more, try both Airtel default profile or create a new profile with PDP Type IPv4 only/ IPv4&IPv6 for Airtel SIM, if it still doesn't work, please share with us screenshots of Advanced->Status page, Advanced->Network->Internet page along with system log file.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, the signal strength shows 0%, please make sure the two antennas are installed properly and ensure the Airtel 4G signal in the area is strong.
Try to create a new profile for Airtel and set PDP Type as IPv4 only to see if it helps.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1798
Replies: 17
Voters 0
No one has voted for it yet.