Cannot open port and Wake on Wan

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Cannot open port and Wake on Wan

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cannot open port and Wake on Wan
Cannot open port and Wake on Wan
2023-06-30 16:15:08
Tags: #Port Forwarding #wake on lan
Model: Archer VR1210v  
Hardware Version:
Firmware Version: 1.13.0

Hi everyone,

I have a big problem that's going on since 3 months ago.

I cannot open ports, and my ISP has everything opened,

My goal is WOL, especially Wake on Wan, and I followed the official TP Link guide.

I have done all the stuff on windows and on bios, then IP and MAC binding and virtual serves.

It's not only a issue of WOL, in general if I check port with the specific website, it says it's always close.

What can i do?

thanks

  0      
  0      
#1
Options
1 Reply
Re:Cannot open port and Wake on Wan
2023-07-01 10:58:07 - last edited 2023-07-02 17:50:51

  @leoleoleoleo 

 

Follow this guide to port forward on your modem router.

Make sure that your public IP address is the same as your modem WAN IP address - you may be behind double NAT or CG-NAT.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options