Does XE75 require modem router to be in bridge mode?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have connected Deco XE75s to anTP-Link Archer AC2100 modem router.
Should this modem router now be set to bridge mode?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
Deco XE75 pro is also a wireless router by default so it would be great to set Archer AC2100 to bridge mode so that we could get rid of double NAT issues.
Best regards.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, you could start checking the IPV4 address on the Deco APP>More>Internet Connection.
Then please go to https://whatismyipaddress.com, the address here would be the internet IP address on the AC1200, not the one on Deco.
Or you might also find the wireless clients from AC1200 would have a different IP range from the devices connected to Deco.
Later, if you need to open any ports or use DDNS service for clients behind Deco, you might have two NATs/firewalls to get through.
But in other words, if you did not have any worries about remote access, two NATs are still able to provide proper internet connection and network speed so that it does not have to set AC1200 into bridge mode.
best regards.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1698
Replies: 4
Voters 0
No one has voted for it yet.