Archer MR 600 Auto Reset config
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Archer MR 600 Auto Reset config
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR 600 4g router resets /clears its config at boot and then comes up with factory default settings.
This router is used for Surveillance in the mountains, but with this "feature" it is useless.
How on earth is this possible?
I see on the forums that other people also experienced similar problems, with no solition.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@baelter
Solution: Unfortunately; buy another brand router. MR-routers turned out to be unreliable. Tip; Where are you located? Have you experienced change in signal behavior with your carrier before the problems started?
- Copy Link
- Report Inappropriate Content
@Ericcc That could definatly be the culprint as the router is installed in a RV.
- Copy Link
- Report Inappropriate Content
Hello @Sunshine
Supporting @Ericcc issue, regarding the router auto reset for Archer MR600 Hardware V1 with Firmware Version 1.3.0.
I also experienced the same thing, it automatically resets the entire configuration I am not sure if the intermittent power interruptions cause it.
I am from the Philippines and using Globe Telecom with 4G+ connection.
This drove me crazy, as it reset to the default settings of the router like its first run from the box.
If this router only supports OpenWRT, I won't use this faulty OEM stock firmware.
Hopefully, this solve the issue.
Thanks,
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1776
Replies: 13
Voters 0
No one has voted for it yet.