Web access Deco M4R Wifi Coverage Settings what are these for?
When I access my Deco M4R via browser and go to System > System Parameters I see a section called WiFi Coverage as seen in below screenshot, at default is shows the three Wireless networks as "Please Select" Question is should I set these to something?
Secondly the WAM Unicast section is greyed out is that correct?
Additional info:
When I set the settings to any choice Low Med or High I see pop up "Operation Failed" (see second screenshot below)
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Thanks for the update.
It seemed like you hadn't attached the picture this time on the iPad.
It sounds strange why it just didn't work on the mini Mac. I am a little curious if you checked on the iPad before when we were still on the official firmware.
If possible, it is also suggested to clear the DNS caches on the mini Mac or access the browser in incognito mode.
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Hi David, Thanks for your continued support ..
I have a further update with Beta F/W, accessing from my Mac, I tried clearing the cache on Safari and now I can access the System Parameters UI page ... however on all browsers I see a small issue I see a small black pop up that says "Operation Failed" (even though I have not changed or selected anything) seen for first few seconds of accessing the "System Parameters" page (see screenshot below)
Also note in screenshot below I have selected/turned on the IGMP setting by default on Bets f/w it was off.
- Copy Link
- Report Inappropriate Content
Exact this happens also in my situation, but with the latest official firmware, via chrome or edge browser.
- Copy Link
- Report Inappropriate Content
I also have these settings. They are in low.
should I put them in high?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 4289
Replies: 24