Archer AX53 IoT config lost after reboot or power loss
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Archer AX53 IoT config lost after reboot or power loss
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi here, in the last firmware, has included a separated network for IoT devices. When power lost or reboot the router, this network turning off, and must enter in his config an enable again. Please, fix this with a firmware release and not abandone it.
Greets.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, please try changing it back to Router mode first, then reset the device to factory defaults and then configure it to AP mode again manually to see if the issue can be resolved this way.
If the problem still exists, please let me know the model no., hardware and firmware version of your TP-Link device, and also its operation mode like router mode or AP mode.
- Copy Link
- Report Inappropriate Content
Hi, for this issue, you could also refer to the solution in this thread: Archer AX53 V1 and Archer AX72 Pro V1 IoT Network Config Lost after Reboot
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1444
Replies: 12
Voters 0
No one has voted for it yet.