can't access to my epson printer (wireless connected) from wired network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

can't access to my epson printer (wireless connected) from wired network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
can't access to my epson printer (wireless connected) from wired network
can't access to my epson printer (wireless connected) from wired network
2024-01-24 10:41:52 - last edited 2024-01-24 10:42:58
Model: Deco M5  
Hardware Version:
Firmware Version: 1.7.3

 

Wifi router is a Tp-Link Deco M5  (router mode, wireless network 192.168.68.xxx, isp router eth 192.168.1.140)

My printer is an Epson xp 7100 connected via wireless to the Deco router (192.168.68.108)

I can print with any wireless connected device (from the network 192.168.68.xxx) but I can't from the network (192.168.1.xxx). My windows 11 pc (192.168.1.110) can't find the printer, even in manual config giving the ip address of the printer).

On the Deco Upnp is enabled.

Is there any way to be able to print from 192.168.1.xxx (port forwarding?) using this diagram ? 

thanks

Alan

 

 

  0      
  0      
#1
Options
3 Reply
Re:can't access to my epson printer (wireless connected) from wired network
2024-01-24 12:51:31

  @MrRicciolo 

 

I would recommend configuring Deco mesh to run in Access Point mode. That will put everything on 192.168.1.xxx network and allow all devices on your home network access printer.

 

See Switching a Deco to Access Point (AP) Mode

  1  
  1  
#2
Options
Re:can't access to my epson printer (wireless connected) from wired network
2024-01-24 13:30:39

  @Alexandre.

Thank you. In fact when I was in AP mode I didn't have any problems. But now I need a configuration working in router mode.

I could also connect the printer to the 192.168.1.xxx network via cable, and everyone could print (including wireless users). I did this test and it works.

However, it would be better for me not to have to move the printer and so I was wondering if there wasn't a solution by playing around with the Deco settings.

  0  
  0  
#3
Options
Re:can't access to my epson printer (wireless connected) from wired network
2024-01-24 13:43:45 - last edited 2024-01-24 13:52:25

  @MrRicciolo 

 

1. Have you tried connecting printer to ISP router by WiFi on 2.4GHz band, or are they too far from each other even for 2.4GHz?

 

2. Port forwarding is common way to access printer behind the router, which is what your Main Deco is. I think you would need 9100 port. See How to set up Port Forwarding feature on the Deco Any issues with that? 

Make sure you use IP reservation feature in Deco and not configure static IP address on printer itself.

  1  
  1  
#4
Options