Two uplink cables from switches (SG2210P) to router (ER605)?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Two uplink cables from switches (SG2210P) to router (ER605)?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Two uplink cables from switches (SG2210P) to router (ER605)?
Two uplink cables from switches (SG2210P) to router (ER605)?
2024-01-25 17:27:29
Model: ER605 (TL-R605)  
Hardware Version:
Firmware Version:

Hello, I have one ER605 router, and two SG2210P switches. I would like to run two ethernet links from each switch to the router for redundancy. With RSTP enabled globally on the switches, and spanning tree enabled per port, when two cables are plugged in between switch and router the router will pop up alerts that ports are being blocked, and loops will occur until the router crashes. Is there any way to achieve this? While I know omada routers do not currently support LAG, I am not concerned about bandwidth, only redundancy. Thanks for any help!

  0      
  0      
#1
Options
1 Reply
Re:Two uplink cables from switches (SG2210P) to router (ER605)?
2024-01-26 01:03:02

  @sammmmmmmm 

 

Since you cannot create a LAG with the router, try a configuration with just one cable from each switch. It looks like those switches are connected together so you will still have redundancy.

Kris K
  1  
  1  
#2
Options