Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Deco X50 - 2nd one keeps disconnecting from 1stDeco

< Deco

Deco X50 - 2nd one keeps disconnecting from 1stDeco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X50 - 2nd one keeps disconnecting from 1stDeco

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

robbyke

2024-01-26 12:14:08

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-10-13

Deco X50 - 2nd one keeps disconnecting from 1stDeco

2024-01-26 12:14:08

Model: Deco X50

Hardware Version: V20

Firmware Version: 1.4.1 b20231122 R.40485

Hello I have 2 deco's x50. One where the ONT Fiber comes in directly, and the other at approx 10m

I see that the connection between these 2 is the max reception.

But from time to time, the 2nd deco is disconnected from the 1st it seems. Only thing I can do isunplu the 2nd one, and replug - in. Than for a few days its fine again

What could be the issue?

2 Reply

David-TP

2024-01-29 06:02:59

Posts: 12361

Helpful: 1710

Solutions: 1120

Stories: 9

Registered: 2020-04-14

Re:Deco X50 - 2nd one keeps disconnecting from 1stDeco

2024-01-29 06:02:59

@robbyke

Hi, Thank you for the feedback.

How about the signal source strength on the satellite Deco X50, 2 or 3 WiFi bars here?

Would it help if you move the satellite X50 a little closer to the main Deco X50?

Wait for your reply and best regards.

Check What's Currently Going on With Deco Deco Early Access Firmware Open for Test! Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.

robbyke

LV1

2024-01-29 06:05:43

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-10-13

Re:Deco X50 - 2nd one keeps disconnecting from 1stDeco

2024-01-29 06:05:43

Always 3 bars on the wifi symbol, so I don't see why should put it closer. If I need to put a deco every 5m then I guess it's time to look at another solution :-) It's all flat surface also.

Deco X50 - 2nd one keeps disconnecting from 1stDeco

Deco X50 - 2nd one keeps disconnecting from 1stDeco

Information

Voters 0

Tags