Deco M4 Took Longer Time To Get Internet After Reboot
When i reboot my Deco M4 units idk why they took longer time to get internet access after i rebooted them or when they turned back ON after power supply back. Main deco get WAN ip but internet took longer time to work until ports 53, 80 and 443 not gonna back ON because after rebooted ports 53, 80 and 443 went OFF for few minutes until they back ON i can't access internet connection. This happened on 1.5.8 too and now on beta firmware 1.7.0 too. My all decos are using Router Mode. I tried all DNS servers still same problem.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Nice to see you again.
This feedback is like the last you made here:
https://community.tp-link.com/en/home/forum/topic/650196
I guess further assistance from the engineers last time didn't go well. Have you checked the email reply #TKID240120203 from the engineers?
Thank you very much and best regards.
- Copy Link
- Report Inappropriate Content
@David-TP Here you can see (W) is not available for main deco (W) means website port 80, 53 and 443 are closed for 2/3 minutes after reboot even my phone is detect both ipv4 and ipv6 but until ports are closed so no internet
- Copy Link
- Report Inappropriate Content
Hi, Thank you for your time and patience throughout this process.
The issue has been forwarded to the engineers. Honestly, I wish you could try to update the email and cooperate with the engineer.
You have described the issue quite clearly but I'm afraid I'm not competent enough to help you find out what caused the temporarily-blocked ports or whether this behavior is expected on 1.7.0 firmware.
Thanks and best regards.
- Copy Link
- Report Inappropriate Content
@David-TP Now i'm on firmware version 1.6.1 which is recently released on official website and still i'm facing same issue.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 376
Replies: 4