Enable Save Button On EC230-G1 with ISP Firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Enable Save Button On EC230-G1 with ISP Firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Enable Save Button On EC230-G1 with ISP Firmware
Enable Save Button On EC230-G1 with ISP Firmware
2024-02-26 20:35:33 - last edited 2024-03-03 12:58:37
Model: Archer C6  
Hardware Version: V1
Firmware Version:

Disabled save button on ISP Firmware router: EC230-G1

 

 

The solution is to inspect element the button and remove the 'disabled' tag, then you can save the changes on the router.

 

  0      
  0      
#1
Options
3 Reply
Re:Disabled Save Button on Remote Managmenet
2024-02-26 22:45:16

  @9kk 

 

This router model is usually IPS provided hence your ISP logo on its web manaagement interface.

If you can't login the device WebGUI reset to its factory defaults holding the reset button for about 10 seconds.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options
Re:Disabled Save Button on Remote Managmenet
2024-02-27 09:18:54

  @terziyski I can log in no problem, but I just want to disable Remote Management(the web page on my WAN IP), but the save button is locked, any other solution or just the reset?

  0  
  0  
#3
Options
Re:Disabled Save Button on Remote Managmenet
2024-02-27 10:21:30 - last edited 2024-02-27 14:54:02

  @9kk 

 

If the router is with a customized FW by the ISP is quite possible that the save button has been disabled on purpose.

Even resetting the router may not help in this case.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#4
Options