“Unable to join network TP-Link_Extender”
My RE220 range extender suddenly stopped working. It might have been after a brief power outage, but I'm not 100% certain of the timing.
I'm trying to set it up again but on the app it just keeps telling me that it is “Unable to join network TP-Link_Extender” and I can't proceed any further with the setup. I had no problems setting it up originally.
While trying to set it up the power light stays solid for a few seconds, then blinks for a few seconds, then all the lights turn on momentarily (including one that is red) and then the cycle starts again.
I have reset the unit multiple times, but nothing changes.
I'm at a loss.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, you could refer to the instructions in the following post:
RE220/RE200/RE190 Keeps Restarting Automatically
Best regards.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, you could refer to the instructions in the following post:
RE220/RE200/RE190 Keeps Restarting Automatically
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 611
Replies: 3
Voters 0
No one has voted for it yet.