RE705x EasyMesh issues

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE705x EasyMesh issues

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RE705x EasyMesh issues
RE705x EasyMesh issues
2024-05-21 21:37:27 - last edited 2024-05-24 09:43:38
Model: RE705X  
Hardware Version: V1
Firmware Version: 1.1.4 Build 20230509

 

Hello, my home network consists of a TP Link XX230v (which supports and has enabled the EasyMesh feature) as my main router, and a RE705x V1.

 

 


My issue is that when I try to add my RE705x V1 as an EasyMesh satellite to my main router, once configured, the devices connected to the satellite WiFi, they don’t have internet access/connectivity, whereas when they are connected to the main router, they do.
(BTW I can’t add it by scanning, because it’s not detected. But through the WPS method I can)

 

If I enter the RE705x web interface after it has been succesfully added as an EasyMesh device, there are some log messages/errors regarding DHCP issues (DHCP detection failed).
 

  0      
  0      
#1
Options
1 Accepted Solution
Re:RE705x EasyMesh issues-Solution
2024-05-24 09:42:47 - last edited 2024-05-24 09:43:38

Never mind, I solved it by disabling the Band Steering option on my main router, doing a Factory reset on the extender and adding it again as a Mesh satellite. Now it's working!✌️

Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:RE705x EasyMesh issues-Solution
2024-05-24 09:42:47 - last edited 2024-05-24 09:43:38

Never mind, I solved it by disabling the Band Steering option on my main router, doing a Factory reset on the extender and adding it again as a Mesh satellite. Now it's working!✌️

Recommended Solution
  1  
  1  
#2
Options