deco x20 configuration with CPE210

deco x20 configuration with CPE210

deco x20 configuration with CPE210
deco x20 configuration with CPE210
2024-07-25 07:36:37 - last edited 2024-07-26 01:21:59
Model: CPE210   Deco X20  
Hardware Version:
Firmware Version:
Hello, at home I have a deco x20 system connected to the Internet in a closet 5 meters next to the purchased CEP210, I also have an external switch, but in the AP installation, the client router unfortunately does not connect to deco even though it can see well, please help. Hello, at home I have a deco x20 system connected to the Internet in a closet 5 meters next to the purchased CEP210, I also have an external switch, but in the AP socket the client router unfortunately does not connect to the deco even though it can see well, please help
  0      
  0      
#1
Options
2 Reply
Re:deco x20 configuration with CPE210
2024-07-26 10:29:14

  @Pawel1986 

Have you configured CPE210 as the Access Point mode? How do you attach it to the Deco? Do you connect the PoE adapter's LAN port to the Deco?

How to Select Operation Mode of Pharos Series Products?

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:deco x20 configuration with CPE210
2024-07-29 20:09:54

Check if the CPE210 is set up in bridge mode and ensure it's properly by flare leggings connected to the Deco X20. Sometimes adjusting the IP settings can help with connectivity issues.

  0  
  0  
#3
Options