Home Network Community > DSL Modem Routers > Connected to NBN FTTP today, now the VR2800 won't complete boot up.
< DSL Modem Routers

Connected to NBN FTTP today, now the VR2800 won't complete boot up.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connected to NBN FTTP today, now the VR2800 won't complete boot up.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connected to NBN FTTP today, now the VR2800 won't complete boot up.
Connected to NBN FTTP today, now the VR2800 won't complete boot up.
2024-08-06 08:47:45
Model: Archer VR2800  
Hardware Version: V1
Firmware Version:

I had NBN FTTP installed today. When I came to get the VR2800 working, it started to power up, got as far as WiFi 5G then turned off. The power to the house was switched off for a few minutes, during the installation of the NTD. I've tried several resets, to no avail. What's going on!?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Connected to NBN FTTP today, now the VR2800 won't complete boot up.
2024-08-09 01:34:42

  @Abberlad 

 

Hi, thanks for posting question on our community.

Not sure whether the router was broken during installation when your house was switched off power.

After factory reset, if the WiFi LED is off, please try to press the Wi-Fi ON/OFF button.

Or you may share a short video to show the current problem when powering on the DSL modem router.

 

 

 

 

 

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 343

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.