DECO AX1500 AP Mode

Wilhem

2024-08-14 17:35:49 - last edited 2024-08-16 02:07:22

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-08-14

DECO AX1500 AP Mode

2024-08-14 17:35:49 - last edited 2024-08-16 02:07:22

Model: Deco

Hardware Version:

Firmware Version:

Hi,

I just purcahsed a 3 Deco AX1500 package in order to improve my wifi in my house.

I want them to run in AP mode, cause I have already my router, a Netgear RAX20, and I want them to run the same SSID.

In the app, I have to set up first a new wifi network, and after that, I can go into AP Mode.
After that, why is the wifi I just created still available?

I don't see new devices connecting the AP, even after reboot.

Do all my APs have to be connected to my router with cable?

Thanks for your help.

Wilhem

1 Accepted Solution

David-TP

2024-08-15 06:55:05 - last edited 2024-08-16 02:07:22

Posts: 12539

Helpful: 1738

Solutions: 1205

Stories: 9

Registered: 2020-04-14

Re:DECO AX1500 AP Mode-Solution

2024-08-15 06:55:05 - last edited 2024-08-16 02:07:22

@Wilhem

Hi, welcome to the community.

Only one Deco X1500 needs to be connected to the Netgear RAX20.

In "Access Point mode", Deco would not automatically copy the SSID of Netgear RAX20. It will still broadcast its own SSID but you could change the SSID to be the same as Netgear RAX20 to reduce the roaming time when mobile devices switch from Netgear to Deco.

Compared with setting the same SSID, it is suggested to disable the WiFi on Netgear RAX20 and use the Deco Mesh SSID only.

Thank you very much and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶Deco X50-5G-V1-1.2.0 Supports WireGuard VPN, Hybrid Mesh and More Try to leave a Message if urgent help is required.

Recommended Solution