Devices not connecting to closest Deco
Hi,
I have 3x TP Link Deco E4 extenders throughout my house to make my network seemless, and my Hardware is set to automatically move between the Deco devices, as intended. However some devices seem to latch on to the furthest away points on the network, which results in me getting a terrible signal. Is it possible to configure the network to make it so that I connect to the closest extender rather than the strongest.
For reference, I have the Main deco, and a booster on the ground floor (main unit next to the router, booster at the other end of the house), another booster on the first floor, and a final booster on the second floor, this covers the entire house.
check if fast roaming is enabled in deco app
and also check in the settings on the client devices whether mesh is enabled on the problematic devices
In general, there is one rule: only the client end device decides which point to connect to
you can try to direct the device to one point or another using certain methods or settings, but the final decision on this is made only by the end client device
check if fast roaming is enabled in deco app
and also check in the settings on the client devices whether mesh is enabled on the problematic devices
In general, there is one rule: only the client end device decides which point to connect to
you can try to direct the device to one point or another using certain methods or settings, but the final decision on this is made only by the end client device