TP-Link 5G router ArcherNX200 has no easyMesh integration with TP-Link RE305 (WPA3)
Hello ,
TP-Link Archer NX200 I don't see the RE305 as RE or part of Mesh , i see it as normal wifi client .
TP-Link Archer NX200
Firmware Version:1.0.0 3.0.0 v60a2.0 Build 240309 Rel.4758n
Hardware Version:Archer NX200 v1.0 00000000
wifi secuirty mode WPA2-PSK[AES]+WPA3-Personal
in the router EasyMesh is enabled however it says that WP3-Personal and WPA2-Enterprise are unavailable !
RE305:
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
In case you have "Band Steering" activated in the Wireless Settings menu of the NX200 switch it off and then try again if the RE305 can connect as EasyMesh device.
Edit: If the above by itself doesn't help also try to connect the two devices using the WPS method. (i.e. first press the WPS button of the NX200 and right after that press the WPS button of the RE305)
- Copy Link
- Report Inappropriate Content
Hi,
In case you have "Band Steering" activated in the Wireless Settings menu of the NX200 switch it off and then try again if the RE305 can connect as EasyMesh device.
Edit: If the above by itself doesn't help also try to connect the two devices using the WPS method. (i.e. first press the WPS button of the NX200 and right after that press the WPS button of the RE305)
- Copy Link
- Report Inappropriate Content
Hi @Amer-Hash
As woozle said, you can try WPS buttons to create easymesh network between NX200 and RE305.
It is recommended that you can factory reset the RE305 before you set up easymesh network:
Keep power on, Use a pin to press the reset button(hole) for 1 second to reset the extender
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 239
Replies: 3