Support for downstream Cisco RV345
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I plan to add a 4/5G wireless router as backup line to our Cisco router. I am unable to find (bad google-fu?) a comprahensive manual that describes what configuration options there are. I suppose I need to configure something on the router side (Cisco IOS) in order to use the 5G modem. The router has 2 WAN ports, and I plan to use WAN2 for the 5G connection. The model I am looking at is the NX200.
Anyone?
Hi, welcome to our community.
According to your description, my suggestions list below:
1. Connect Archer NX200 to LAN port of your Cisco router.
2. Set up EWAN mode on NX200, configure it and set same wireless settings as your Cisco router.
Please log into the web interface of NX200 and go to Advanced -> Network ->Internet. Make sure that the Default Gateway is Auto, and then choose the WAN Priority as EWAN.
3. Then, if your Cisco router disconnects, the NX200 will lose internet and switch to 5G/4G router mode automatically. And your device should connect to NX200's network.
Hi, welcome to our community.
According to your description, my suggestions list below:
1. Connect Archer NX200 to LAN port of your Cisco router.
2. Set up EWAN mode on NX200, configure it and set same wireless settings as your Cisco router.
Please log into the web interface of NX200 and go to Advanced -> Network ->Internet. Make sure that the Default Gateway is Auto, and then choose the WAN Priority as EWAN.
3. Then, if your Cisco router disconnects, the NX200 will lose internet and switch to 5G/4G router mode automatically. And your device should connect to NX200's network.