TP-Link Community > Tapo Smart Light Bulb > tp link lights pairing failed
< Tapo Smart Light Bulb

tp link lights pairing failed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

tp link lights pairing failed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
tp link lights pairing failed
tp link lights pairing failed
2025-01-14 07:56:01 - last edited 2025-03-05 11:20:04
Tags: #Installation #tplink tapo l630
Model: Tapo L630  
Hardware Version:
Firmware Version:

a few days a go i purchase some new tapo l630 smart lights and was strugging to setup via wifi.  The initial problem i had to resolved the ssue was to make sure in your router settings to make sure the 2.4ghz bandwidth is set to channel 11 and not use auto.  If you use auto the pairing will fail.  

 

They did not mention this in the manual so this solution worked for me

  1      
 
  1      
 
#1
Options
1 Accepted Solution
Re:tp link lights pairing failed -Solution
2025-01-15 09:01:27 - last edited 2025-03-05 11:20:04

  @arousek 

 

Thank you for your sharing! I'll help to submit your feedback to the relevant team for review. 

 

Channel 11 on the 2.4GHz WiFi band is relatively less crowded, along with channels 1 and 6. If fixing the channel to 11 enables the bulb to successfully connect to the router's WiFi, it indicates that the channel previously chosen by the router was crowded. In such cases, it is feasible to switch the 2.4GHz WiFi channels.

 

This approach is also applicable for situations where devices in the network experience WiFi disconnections.

 

 

 

Related Article

What should I do if I fail to configure the Tapo devices

▶ Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual Modes ▶ Tapo Camera Image Style & Image Brightness Try out a different image style for your camera!
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:tp link lights pairing failed -Solution
2025-01-15 09:01:27 - last edited 2025-03-05 11:20:04

  @arousek 

 

Thank you for your sharing! I'll help to submit your feedback to the relevant team for review. 

 

Channel 11 on the 2.4GHz WiFi band is relatively less crowded, along with channels 1 and 6. If fixing the channel to 11 enables the bulb to successfully connect to the router's WiFi, it indicates that the channel previously chosen by the router was crowded. In such cases, it is feasible to switch the 2.4GHz WiFi channels.

 

This approach is also applicable for situations where devices in the network experience WiFi disconnections.

 

 

 

Related Article

What should I do if I fail to configure the Tapo devices

▶ Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual Modes ▶ Tapo Camera Image Style & Image Brightness Try out a different image style for your camera!
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 1

Views: 497

Replies: 1

Tags

Installation
tplink tapo l630
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.