Problems with print server on W8980
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Problems with print server on W8980
Region : Argentina
Model : TD-W8968
Hardware Version : V2
Firmware Version :
ISP :
Hi. I set up my new W8980 yesterday and I have a problem trying to get the print server working. Here are the details:
I have a Canon iP4600 that I connected to the router via USB. The printer is connected to the USB 2 port and the light is on.
The print server shows as being enabled in the router settings.
I went through the process of setting up a standard TCP/IP port using the print server address of 192.168.1.1 using the process described here.
The process appears to go ok and the printer status shows as 'ready', but when I try to print I get an error message saying that I can't connect to the printer.
Any suggestions to figure out the problem?
Thanks
Simon
Model : TD-W8968
Hardware Version : V2
Firmware Version :
ISP :
Hi. I set up my new W8980 yesterday and I have a problem trying to get the print server working. Here are the details:
I have a Canon iP4600 that I connected to the router via USB. The printer is connected to the USB 2 port and the light is on.
The print server shows as being enabled in the router settings.
I went through the process of setting up a standard TCP/IP port using the print server address of 192.168.1.1 using the process described here.
The process appears to go ok and the printer status shows as 'ready', but when I try to print I get an error message saying that I can't connect to the printer.
Any suggestions to figure out the problem?
Thanks
Simon