NAT table not updating when ISP changes external ip address
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NAT table not updating when ISP changes external ip address
Region : Italy
Model : TD-W8970
Hardware Version : V1
Firmware Version : 0.6.0 2.8 v000c.0 Build 130828 Rel.38099n
ISP : infostrada
If i define a portforwarding for a host in my LAN, the NAT association works good (i can reach my host from WAN) until the ISP changes external ip address of the router.
In that case I have to disable the portforwarding on that host and enable it again to reach my host from WAN.
It seems that the NAT table, where all portforwardings are defined, is not updating, when ISP changes external ip address .
Is there a solution ?
Thanks
Model : TD-W8970
Hardware Version : V1
Firmware Version : 0.6.0 2.8 v000c.0 Build 130828 Rel.38099n
ISP : infostrada
If i define a portforwarding for a host in my LAN, the NAT association works good (i can reach my host from WAN) until the ISP changes external ip address of the router.
In that case I have to disable the portforwarding on that host and enable it again to reach my host from WAN.
It seems that the NAT table, where all portforwardings are defined, is not updating, when ISP changes external ip address .
Is there a solution ?
Thanks