Home Network Community > DSL Modem&Routers > how to set virtual lan port tp go to internet
< DSL Modem&Routers

how to set virtual lan port tp go to internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

how to set virtual lan port tp go to internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
how to set virtual lan port tp go to internet
how to set virtual lan port tp go to internet
2014-02-20 21:08:22
Region : Italy

Model : TD-W8960N

Hardware Version : V3

Firmware Version : TD-W8960N v3 0x00000002

ISP : telecom italia

Good morning,
My adsl modem router is connected by a pppoa connection setted by quick setup

I already configured by interface grouping 3 lan respectevly
192.168.1.0 / 24 on lan 1 port interface wan wan service quick setupped
192.168.2.0 / 24 on lan 2 port no interface wan
192.168.3.0 / 24 on lan 3 port no interface wan
I connected 3 client
192.168.1.100/24 on lan 1 port
192.168.2.100/24 on lan 2 port
192.168.3.100/24 on lan 3 port

I canroute between the different net (share, ping, http etc.)
I can browse to internet only by the client connected to lan 1 port

How could i browse to internet by the client connected to lan 2 port and lan 3 port ?
Thanks
ST
  0      
 
  0      
 
#1
Options
3 Reply
Re:how to set virtual lan port tp go to internet
2014-02-25 17:36:54
You mistook the fuction, only the LAN port connected the the PPPOA interface can surf Internet in fact. This function is used for IPTV, not VLAN.
  0  
  0  
#2
Options
thanks
2014-02-25 21:29:28

lee99 wrote

You mistook the fuction, only the LAN port connected the the PPPOA interface can surf Internet in fact. This function is used for IPTV, not VLAN.
Very thanks for the answer.
I have some news.
I can go to Internet with a client connected by every Group of ports
This Group must have an wan interface that is also the current default gateway.
If I change the default gateway with setting it to another wan interface I can go to Internet by the Group of Virtual lan por(s)t coupled with the changed interface.
The problem is that the GUI interface doesn't permit to couple different group with the same wan intrface
Is it possible, by telnet ?
If yes how could I set it ?

Thanks in advance
Stefano Tufillaro
  0  
  0  
#3
Options
Re:how to set virtual lan port tp go to internet
2014-03-07 00:32:56
solved
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 905

Replies: 3

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.