Home Network Community > DSL Modem&Routers > TD-W8980 Using with a statis subnet of IP addresses
< DSL Modem&Routers

TD-W8980 Using with a statis subnet of IP addresses

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TD-W8980 Using with a statis subnet of IP addresses

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TD-W8980 Using with a statis subnet of IP addresses
TD-W8980 Using with a statis subnet of IP addresses
2014-04-16 03:22:30
Region : UnitedKingdom

Model : TD-W8980

Hardware Version : V1

Firmware Version : 0.6.0 1.3 v000e.0 Build 131012 Rel.51720n

ISP : Eclipse.net.uk

Hi,

I have purchased a TD-WD8980 to use at with ADSL, I have a range of IP addresses 92.252.200.77/26 (92.252.200.77-92.252.200.90). However I can't seem to configure the router to use them, can anyone provide any advice?

Thanks.
  0      
 
  0      
 
#1
Options
4 Reply
Re:TD-W8980 Using with a statis subnet of IP addresses
2014-04-16 17:48:03
Read page 23 of the manual <---hyperlink
  0  
  0  
#2
Options
Re:TD-W8980 Using with a statis subnet of IP addresses
2014-04-16 17:54:18
Hi,

Thanks for that but there isn't any options there to configure the ADSL username and password on that page, have you set this up yourself?

Thanks.
  0  
  0  
#3
Options
Re:TD-W8980 Using with a statis subnet of IP addresses
2014-04-16 19:11:02

ojms wrote

Hi,

Thanks for that but there isn't any options there to configure the ADSL username and password on that page, have you set this up yourself?

Thanks.


Does your ISP use PPPoE or PPPoA? Look at p.27 or p.29. Did you run through the setup wizard? Have a good read through the manual and arm yourself with your ISP's required settings.
  0  
  0  
#4
Options
Re:TD-W8980 Using with a statis subnet of IP addresses
2014-04-16 19:22:14
They use PPPoA. I have been through the setup wizard and can get online.

However all the outbound connections are from the same IP and also if the router loses connection then it can't reconnect as there is a conflict with the LAN IP being the same as the WAN IP.

With my previous netgear router the outbound connections were from each of the fixed IP addresses and if the router loses connection then you don't need to wipe the settings and set it up again.

Thanks.
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 448

Replies: 4

About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.