Trying to use TD-W8968 as wireless router only
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Trying to use TD-W8968 as wireless router only
Region : India
Model : TD-W8968
Hardware Version : V1
Firmware Version : 0.6.0 0.4 v0005.0 Build 130217 Rel.62075n
ISP : Hathway
I changed my broadband provider because i was not getting enough speed. My new broadband provider uses f-connector wire. Wire is connected to Cisco DPQ2160 modem. Output from modem is via ethernet cable.
I connected this ethernet cable to LAN4/WAP port of TPLINK TD-W8968 and configured it . But it's not working. Internet is not working.
I configured it by these steps:
Quick Setup -> Wireless Router Mode -> Dynamic IP.
Is there any additional setting or configuration i need to do?
Internet is working if i'm connecting ethernet cable directed to my laptop.
Model : TD-W8968
Hardware Version : V1
Firmware Version : 0.6.0 0.4 v0005.0 Build 130217 Rel.62075n
ISP : Hathway
I changed my broadband provider because i was not getting enough speed. My new broadband provider uses f-connector wire. Wire is connected to Cisco DPQ2160 modem. Output from modem is via ethernet cable.
I connected this ethernet cable to LAN4/WAP port of TPLINK TD-W8968 and configured it . But it's not working. Internet is not working.
I configured it by these steps:
Quick Setup -> Wireless Router Mode -> Dynamic IP.
Is there any additional setting or configuration i need to do?
Internet is working if i'm connecting ethernet cable directed to my laptop.