[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980
[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980
2014-07-09 06:07:41
Region : Venezuela

Model : TD-W8980

Hardware Version : V1

Firmware Version : 0.6.0 1.5 v000e.0 Build 140408 Rel.49241n

ISP : CANTV


Hi, to open port to a specific application. we do a number of requirements:

. 1 - We must set the IP address of our PC with the corresponding MAC address in "DHCP Server > Address Reservation" and "IP & MAC Binding > Binding Settings".









. 2 - We know that port number and protocol the application uses, for that we use the tool NirSoft CurrPorts.




In my case, I'll open port 9594 on the application of remote access, RealVNC.

. 3 - We open the port "Forwarding > Virtual Server" and "Forwarding > Port Trigger".









Then try connecting remotely from another PC, SmartPhone or Tablet with the Viewer application.

Note: This guide can be used for other applications.
  0      
  0      
#1
Options
2 Reply
Re:[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980
2014-07-09 14:15:43
You must to look in RealVNC settings and will check number of application port and then make forwarding configuration.
  0  
  0  
#2
Options
Re:[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980
2014-07-09 23:34:27

jimasek wrote

You must to look in RealVNC settings and will check number of application port and then make forwarding configuration.

excuse to forget. default is port 5900 and 5800, but I will change my preference.


  0  
  0  
#3
Options

Information

Helpful: 0

Views: 3795

Replies: 2