How to enable IPv6 with IPv4 together for all WAN connections?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to enable IPv6 with IPv4 together for all WAN connections?
Region : NewZealand
Model : TD-W8980
Hardware Version :
Firmware Version : 0.6.0 1.7 v000e.0 Build 140619 Rel.51112n
ISP :
Hello there
Currently I have a PPPoA WAN connection configured on my TD W8980 router. I found out that some IPv6 connections from my Android device are refused on the gateway because the WAN connection is not IPv6 enabled.
I asked my provider and they assured, IPv6 should be possible and that I have to look into the router configuration.
So, I found out that an IPv6 option is missing for my existing WAN connection. But I spotted that the other type PPPoE has an IPv6 option.
What should I do? Should I set up a second WAN connection based on PPPoE while leaving the other PPPoA one active?
Thanks for advice and consultation!
- Michael
Model : TD-W8980
Hardware Version :
Firmware Version : 0.6.0 1.7 v000e.0 Build 140619 Rel.51112n
ISP :
Hello there
Currently I have a PPPoA WAN connection configured on my TD W8980 router. I found out that some IPv6 connections from my Android device are refused on the gateway because the WAN connection is not IPv6 enabled.
I asked my provider and they assured, IPv6 should be possible and that I have to look into the router configuration.
So, I found out that an IPv6 option is missing for my existing WAN connection. But I spotted that the other type PPPoE has an IPv6 option.
What should I do? Should I set up a second WAN connection based on PPPoE while leaving the other PPPoA one active?
Thanks for advice and consultation!
- Michael
