Home Network Community > Wi-Fi Routers > AC 1200 and Starlink
< Wi-Fi Routers

AC 1200 and Starlink

AC 1200 and Starlink

AC 1200 and Starlink
AC 1200 and Starlink
2025-04-25 10:16:20 - last edited 2025-05-18 15:43:59
Tags: #Network Connectivity #Starlink
Model: Archer C1200  
Hardware Version:
Firmware Version:

I cannot get the AC 1200 to work with the starlink router.  I put the starlink router generation 2 in bypass mode and I get basically no speed out of the ac1200 set as a router.   When I just use the starlink router by itself everything is fine.!Any ideas? Others seem to not have this issue.

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:AC 1200 and Starlink-Solution
2025-04-27 03:38:02 - last edited 2025-05-18 15:43:59

Hi @jolondon,

Thank you for reporting your questions to our community.

Before you try the suggestions of terziyski, please try hard reset the Archer C1200 firstly.

Press and hold RESET button for more than 5 seconds to reset the router to its factory default settings.

 

Check Out the Latest Posts: △Pre-release Firmware for Archer AX50 Introduces New Parental Control Features and Enhancements △Pre-release Firmware for Archer AX80 Supports EasyMesh in AP Mode, DoH/DoT, ECO Mode, and More △Introducing AI QoS: Elevate Your Gaming Experience on the Archer GE800 Gaming Router △Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN △Tether KidShield Test Recruitment - Safeguarding Children's Online Experience
Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:AC 1200 and Starlink
2025-04-25 13:01:57

  @jolondon 

 

Did you follow these instructions for Starlink gen 2 ? They are quite straight-forward.

The problem may have been caused by the AC1200 configuration - reset the AC1200 to its factory settings and reconfigure from scratch.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:AC 1200 and Starlink-Solution
2025-04-27 03:38:02 - last edited 2025-05-18 15:43:59

Hi @jolondon,

Thank you for reporting your questions to our community.

Before you try the suggestions of terziyski, please try hard reset the Archer C1200 firstly.

Press and hold RESET button for more than 5 seconds to reset the router to its factory default settings.

 

Check Out the Latest Posts: △Pre-release Firmware for Archer AX50 Introduces New Parental Control Features and Enhancements △Pre-release Firmware for Archer AX80 Supports EasyMesh in AP Mode, DoH/DoT, ECO Mode, and More △Introducing AI QoS: Elevate Your Gaming Experience on the Archer GE800 Gaming Router △Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN △Tether KidShield Test Recruitment - Safeguarding Children's Online Experience
Recommended Solution
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 429

Replies: 2

Tags

Network Connectivity Starlink
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.