Hardware issue,ethernet cable?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello everyone,
I am having issues with a TP Link archer C50.
Using it as an access point,it doesn't seem to read the ethernet cable from the wall plug to the Wan port of the device.I tried 4 different cables and rebooted it and hard reset as described in the manual.Still,the right led on the archer C50 blinks and there is no internet access.
At any time I connect the pc with the internet wall plug,I have internet.
I firstly had it set up and worked fine,then I disconnected from the power plug to do some work on the table and since then..I am here.
Grateful for any help,in advance 🙂
To troubleshoot this issue you have to open the router web managment page in a web browser and check the WAN / Etehrneport status:
Here's how to find your router IP address.
To troubleshoot this issue you have to open the router web managment page in a web browser and check the WAN / Etehrneport status:
Here's how to find your router IP address.