XE75 Pro Firmware for Heavy IoT Users
XE75 Pro Firmware for Heavy IoT Users
Hi there TP-Linkers.
I have 3 x XE75Pro in my home.
I have a *lot* of smart home (mostly on the 2.4Ghz) as such the initial use of XE75 Pro was pretty wonky as the balance of them was off.
I have since then created the IoT SSID and migrated all of the IoT nodes into this SSID.
I have not enabled the 6Ghz network for anything else than intern-node traffic. (I tried to merge it with the 5Ghz and that was not a good idea as it stalled all traffic)
I am running a pre-release / beta version of the firmware (have been for more than 6 months now).
New firmwares are being released but I am asked to stay at current release until further notice.
What I want to know is, when can I start taking official releases? I mean at one point what I am running must become mainstream no?
If not - should I just sell these nodes and get a newer hardware from TP or other??
Thanks.
/Jonas
PS.
I have 25 5Ghz clients and 32 2.4Ghz clients and the nodes are connected wirelessly (still trying to run wires in the house but it is hard).
Ds.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, nice to see you again.
The beta firmware for Deco XE75 Pro_V2 has been sent.
Is your Deco X50-POE V1 or V2? how about the current firmware version?
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP Hi David,
Thanks for the beta firmware.
I have several X50-POE v2 with firmware: Deco X50-PoE(US)_V2_1.4.9 Build 20250110.
The X50-POE has not received a firmware update in a while?
- Copy Link
- Report Inappropriate Content
Thanks - last time I did this updatred I only needed to do it on the Main Deco and all got the update.
This time I connected each one over ethernet to the main and then used the local IP of each node to update. now they are finally all on the same level ;)
Thanks, will run this and report back.
- Copy Link
- Report Inappropriate Content
I finally got them all upgraded, and I have rebooted them all 3 times now.
Only thing is that only the main Deco shows any client connected.
I have restarted a lot of clients to see if they re-attach to other Decos. but for now nothing.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Great! It is quite relieved.😌
Did the beta firmware have any improvements so far?
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
@Jonas-Homekit It has only been a day or so, but I have had significantly more stable connection with my 2.4Ghz devices.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 534
Replies: 19
Voters 0
No one has voted for it yet.