XC220-G3v(IN) Ver 2.8 firmware needed.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

XC220-G3v(IN) Ver 2.8 firmware needed.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

PavanRT

2025-06-06 16:49:13 - last edited 2025-11-18 07:24:44

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2025-06-06

XC220-G3v(IN) Ver 2.8 firmware needed.

2025-06-06 16:49:13 - last edited 2025-11-18 07:24:44

Tags: #Firmware Update

Model: XC220-G3v

Hardware Version: V2

Firmware Version:

I unfornately installed British version of XC220-G3v router. Now when i try to install a beta version which the tp link customer care sent me, i am getting error 4503. So, can someone please help me to update the original firmware for my router. The internet speed is tool low for the british firmware. So please HELP ME.

1 Accepted Solution

Joseph-TP

2025-06-09 10:58:18 - last edited 2025-09-05 12:04:28

Posts: 5589

Helpful: 376

Solutions: 2069

Stories: 0

Registered: 2024-06-22

Re:XC220-G3v(IN) Ver 2.8 firmware needed.-Solution

2025-06-09 10:58:18 - last edited 2025-09-05 12:04:28

Hi @PavanRT,

Thank you for contacting our community.

XC220-G3v is a customized device specifically designed for local Service Providers. Its software is tailored to meet the unique requirements of these providers, ensuring alignment with their specific needs. Due to the specialized nature of the firmware on your device, our ability to provide troubleshooting may be limited.

We can certainly offer some troubleshooting tips that may help resolve your issue. Please consider the following:

1. Reboot the modem and refresh the management page again;

2. Reset the modem for a try.

If the problem persists after trying these steps, we recommend contacting the technical support of your Service Provider who supplied the device, as they are best suited to provide the necessary assistance for your device.

Best Regards~

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More △New Firmware for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.

XC220-G3v(IN) Ver 2.8 firmware needed.

XC220-G3v(IN) Ver 2.8 firmware needed.

Information

Voters 0

Tags