Manual Signal Source Selection on Deco
Hello, I am new to Deco devices. I purchased the device and updated it via the application, but I am facing a problem as I cannot connect piece number 3 to piece 2, as piece number 3 was connected to piece number 1. Also, I do not know what the device update is, if it is V1 or V2, I do not know.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, have you tried to manually set the "Connection Preference":
How to select a preferred signal source on the Deco App
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, have you tried to manually set the "Connection Preference":
How to select a preferred signal source on the Deco App
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
@iFaisal The hardware version is written on the bottom of your Deco. you can also find it by logging in to the web UI.
The firmware version is shown on Deco app when you check for updates
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 140
Replies: 3
Voters 0
No one has voted for it yet.