Using a static IP on Deco X60, gives strange problems

Hi,
I have a very strange issue and i think is a problem with the deco.
Setting a static ip address on the wifi of my s24 ultra works for a couple of seconds and then it stops for almost the same amounts of time. It keeps doing this over and over. So, works and than it does not work...
If i setup as dhcp, everything okay.thoughts?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content

Hi, thanks for the update.
I think you can manually set an IP out of the DHCP range, such as 10.6.8.49/255.255.255.0, in case Deco might assign 10.6.8.57 to another local device.
The LAN subnet mask is 22/255.255.252.0. While on the Samsung phone, it is better to use /24 prefix.
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi, did you manually set a static IP address or via Address Reservation on the Deco?
If it were a manually-configured IP, is it out of the DHCP range?
Can I also have the firmware version of the Deco X60?
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP set up manually on the wireless network.
The ip is within the range of the dhcp of deco.
The firmware is the latest available on the app.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@albgen You can use ip address 192.168.70.1 and subnet mask 255.255.252.0 and DHCP ip address range 192.168.68.50 and 192.168.71.250
- Copy Link
- Report Inappropriate Content

Hi, thanks for the update.
I think you can manually set an IP out of the DHCP range, such as 10.6.8.49/255.255.255.0, in case Deco might assign 10.6.8.57 to another local device.
The LAN subnet mask is 22/255.255.252.0. While on the Samsung phone, it is better to use /24 prefix.
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP had another device with the same ip address and that was the issue.
- Copy Link
- Report Inappropriate Content

Information
Helpful: 0
Views: 145
Replies: 6
Voters 0
No one has voted for it yet.