Failure to connect through my RE200
The router was stopped the connection either WiFi network, I tried to reconnect through the application but could not establish the connection, I reset it multiple times but did not succeed, everyone it tells me unable to connect.I even tried the ethernet connection but failed, I noticed the green led gets fixed for brief period then start to blink again
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello@Moharshe ,
Welcome to our community.
For your case, please refer to the following suggestions:
1. Please plug the extender into another power socket.
2. Hold the reset pinhole until all the lights turn on for one second, then off.
If still same, please contact TP-LINK technical support.
Best Regards.
- Copy Link
- Report Inappropriate Content
Hello@Moharshe ,
Welcome to our community.
For your case, please refer to the following suggestions:
1. Please plug the extender into another power socket.
2. Hold the reset pinhole until all the lights turn on for one second, then off.
If still same, please contact TP-LINK technical support.
Best Regards.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hello @224A127018342 ,
Welcome to our community.
Is your device also RE200? If it doesn't have internet , please refer to What should I do if I fail to configure TP-Link Range Extender?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 245
Replies: 3
Voters 0
No one has voted for it yet.