How to execute "flash set" commands in XX530v?
How to execute "flash set" commands in XX530v?
I've updated to latest firmware, but can't run these commands:
flash set OMCI_FAKE_OK 1
flash set OMCI_OLT_MODE 1
flash set GPON_PLOAM_PASSWD 0123456789
flash set GPON_SN XXXXXXXXXXXXXX
flash set GPON_ONU_MODEL HG8010H
flash set PON_VENDOR_ID HWTC
flash set OMCI_SW_VER1 V3R015C10S106
flash set OMCI_SW_VER2 V3R015C10S106
flash set CUSTOM_OMCI_SW_VER1 V3R015C10S106
flash set CUSTOM_OMCI_SW_VER2 V3R015C10S106
flash set HW_HWVER 635.A
flash set ELAN_MAC_ADDR XXXXXXXXXXXX
I must run these commands for my ISP accept my device!
Please help.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
KaleviHeikkinen wrote
@KaleviHeikkinen Im doing my research to try find something, but its hard. No success until now.
- Copy Link
- Report Inappropriate Content
@reffsZA Web page for XX530v mentions it supports OMCI. Isn't support for this commands what OMCI is all about?
- Copy Link
- Report Inappropriate Content
Hello @VladimirPopescu ,
As I know, OMCI is a standardized protocol (G.988) defined by the ITU-T for remote management of ONUs/ONTs by the OLT over a GPON network. Its functionality is limited by the standard's Management Information Base (MIB). The flash set command is typically a vendor-provided command-line interface (CLI) for the device.
While GPON devices support OMCI (ONT Management and Control Interface), it does not necessarily support vendor-specific flash set commands.
- Copy Link
- Report Inappropriate Content
Joseph-TP wrote
Hello @VladimirPopescu ,
As I know, OMCI is a standardized protocol (G.988) defined by the ITU-T for remote management of ONUs/ONTs by the OLT over a GPON network. Its functionality is limited by the standard's Management Information Base (MIB). The flash set command is typically a vendor-provided command-line interface (CLI) for the device.
While GPON devices support OMCI (ONT Management and Control Interface), it does not necessarily support vendor-specific flash set commands.
@Joseph-TP But aren't these commands available in an another way, so that they end up doing same thing? This is what we need.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 843
Replies: 14
Voters 0
No one has voted for it yet.